2
RULES FOR SAFE OPERATION
FIGURE 1
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1) Screw Driver
(1) Pliers
(1) 7/16" Wrench
When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers
to the outside.
The bottom panel has one galvanized
edge; this is the rear. The front edge
has three holes. See figure 2.
NOTE
2. Line up three holes in bottom panel with holes in
front angle assembly. Start three 1/4" x 1" screws
through bottom panel, then through angle. Secure
screws with flat washers and hex nuts.
Tighten
securely.
See figure 2.
1. Lay the front angle assembly down (flat) on floor
and stand the bottom panel in position as shown in
figure 2.
Preventing accidents is the responsibility of every
equipment operator. The following general safety
precautions must be fully understood and followed by
every operator.
1. Do not at any time carry passengers in this cart. It
is designed for carrying materials only and not
intended to carry passengers.
2. Be careful on any grade (hill) and stay off of steep
grades.
3. Use caution when loading cart to avoid tipping.
4. Avoid large holes and ditches when transporting
loads.
REF. QTY.
DESCRIPTION
Your Farm/Yard Cart carton contains a hardware
package with parts as shown in the chart below
and in figure 1.
Contents of Hardware Pack: (See figure 1)
A
6
Screws, 1/4-20 x 2" Long
B
2
Screws, 1/4-20 x 1-1/2" Long
C
4
Screws, 1/4-20 x 1-1/4" Long
D
25
Screws, 1/4-20 x 1" Long
E
4Cotter Pins
F
37
Hex Nuts, 1/4-20 Thread
G
4Flat Washers, 1-1/2" O.D.
H
33
Flat Washer, 1/4" I.D.
I
4Lock Washers, 1/4
"
J
2
Tube Cap, 1" x 1" Long
HARDWARE REFERENCE CHART
FIGURE 2
1/4" x 1"
1/4" x 2"
1/4" x 1-1/4"
A
B
C
D
F
H
G
E
1/4" x 1-1/2'
J
I
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
