AGPRO AGTL105, Руководство по эксплуатации

Страница: 5 / 9

5
4. Operation speed is better to be 1.2-1.5 km/h.
Ⅴ TENSILITY OF CHAIN
1. Tensility of chain is caused by elasticity inside bonnet. If the machine
has noise or works for successive 200 hours, adjust elasticity and chain.
Adjust parts and components in special workshop. Install bonnet with new
fastening. This maintenance can keep chain and machine bolts in good
condition.
2. Adjust operation depth. Stop engine of tractor. After the parts and
components stop working, loose bolt(6),screw down bolt(7), adjust left
and right braking blocks of adjuster(8), and tighten loosen bolts for
a proper height.
Ⅵ TRANSMISSION
1. When milling cutter is fixed on tractor, adjust length of cardan shaft.
If it is so long that it cuts the outside protective device, file the
bushing short. In a working positing, bushing should be inset into the
other bushing at least 150mmm (see the picture).
When cutting tool is fixed
on tractor, it should get some adjustment.
2. Adjust and install transmission gear (cardan shaft) in special workshop.