AGP 0.75KW115V, Оригинальное руководство пользователя

Страница: 9 / 16

9
the butterfly screw and adjust so that it is parallel and as close
as possible to the surface of the tile to be cut. Then retighten the
screw. Readjust whenever cutting a different thickness tile.
Keeping the blade guard as close as possible is safer and prevents
excessive loss of water.
WATER TRAY
Water is a basic requirement for diamond sawing. The water serves as a coolant to avoid the working surface of
the diamond segments from overheating.
WARNING: Always use a PRCD (GFCI) when operating with water
The water feed system is built into the machine. The water is provided by the water tray which is mounted
below the blade. Thus the blade is partially immersed in water. The operator must fill the tray with water (1.5L)
and maintain the water level in the tray at the maximum for best results. The machine is designed so that most
of the water will recirculate, minimizing water loss during operation. The tray has an overflow level hole to
avoid overfilling the tray. When tilting the motor to make bevel cuts, the tray mounting system allows the water
tray to remain horizontal.
To dismount and mount the water tray
The tray is suspended by pins on its sides which engage in slots in
the tray brackets. To dismount, reach in from the right side of the
machine and lift up slightly on the tray and pull out. (The pins will
follow the tracks in the tray brackets)
To mount the tray: lay the tray flat on the bottom of the machine’s
frame and slide in until the tray touches the bracket. Then lift the
tray evenly straight upward and allow the tracks in the brackets to
guide all four of the pins until it fully engages in place. (If only two
of the pins engage, the tray will be tilted)
PARALLEL CUTTING GUIDE
The parallel cutting guide makes it easy to make straight cuts. The guide clips in place on the table in whatever
position is needed. Further, the guide has a ruler on double links which allows the operator to fine tune the
adjustment while maintaining parallelism with the blade. The table features a scale which can be referred to
when setting the ruler. Ensure that the wing nuts on the ruler are both tight before cutting.
The angular guide plate allows the operator to hold the tiles in a number of different positions for controlled
diagonal cutting. The guide plate engages with the ruler and smoothly slides along it. (See page2.)
1.5L water tray
01
Blade Guard