Agora Models Jaguar E-Type Pack 10, Инструкции по сборке

Страница: 20 / 38

AGORA MODELS
20
5
7
6
8
Before you begin, note that the inner edge of the spoke retainer
ring has a series of ‘teeth’, alternating in size (see picture 6). Each
spoke has a right-angled tip, and a flat head on the opposite end.
Use your tweezers to thread the spokes and hook them into place.
Start by threading a spoke, leading with the tip, through a hole in
the innermost row of holes in the wheel centre. (Note: The spokes in
Stages 78 & 79 are the same.)
Then take another spoke and thread it through the next hole in the
innermost row of the wheel centre. Pull the spoke through the hole
and hook the tip around the next ‘wide’ tooth.
Pull the spoke through the hole and hook the tip around the nearest
‘wide’ tooth that gives the spoke a comfortable fit.
NOTE: The key to fitting the spokes correctly is to adjust the tension on
each spoke as you fit it by gently pushing and/or twisting the wheel
centre with your thumb.
Fit the third spoke in the same way, and continue all the way around
the wheel until you have filled all the holes on the inner row of the
wheel centre. Check that they are hooked around the
wide teeth . If
they are not hooked around wide teeth, the spokes will not fit and the
wheel parts will not fit together at the end of the build.
Stage 79: Rear Left Wheel – Fitting the Inner Spokes
Flat head
Angled tip
Inner row
Wide tooth
Narrow tooth
Outer row