L1
IN
R
1
L2
L1
IN
R
1
L2
L1
IN
R
1
L2
END OF LINE DEVICE
REMOTE INDICATOR
FACP
+VE
-VE
L1
IN
R
1
L2
L1
IN
R
1
L2
L1
IN
R
1
L2
END OF LINE DEVICE
COM. REMOTE INDICATOR
FACP
+VE
-VE
Schematic Wiring Diagram of AGNI-205 (Base) Monitored Detector Circuit With Remote Indicator.
Schematic Wiring Diagram of
(Base) Monitored Detector Circuit With Common Remote Indicator.
AGNI-205
WIRING DIAGRAM
COMPATIBILITY
DETECTOR BASE
INSTALLATION
AGNI Conventional Heat Detector are compatible with all type of Conventional Semi
Addressable and Addressable (using module) Fire Alarm Control Panels.
The AGNI-205 Base made of ABS Plastic, is a conductive base. It has one way locking
mechanism with the detector. The flame class is V-0, The base is required to be fixed before
connecting cables and mounting of Detector.
Technical Specification:-
Operating Temperature (Environmental)
:
10C + 50C
Relative Humidity
:
<95% No condensation
Height
:
16mm
Diameter
:
100mm
Colour
:
White
Material
:
ABS
?
As the detector dose not operate without electrical power, it is advised to check regularly and
ensure that there is no interruption of power supply to the device.
?
The detector should be stored within the recommended range and allowed to stabilize to
room temperature before applying power for successful operation.
?
Installation of the device should be carried out as described in the installation sheet.
?
Detector should be installed in compliance with Bs5389 Part 1 and En54.
?
check the wiring and fix the base of the detector firm to the roof/wall.
?
Fix the detector in the base by the mark-line and rotate the detector clockwise until it reaches
the locked position and ensure that it is tightly fixed to the base.
?
Till completion of installation, do not remover the red plastic dust cover.
?
Calibration sensitivity test per NFPA code is required to be carried out once the installation of
device is complete.
Y-51, OKHLA INDUSTRIAL AREA PAHSE.-II NEW DELHI 110020 (INDIA)