RATTLER LRF
USER MANUAL
15
To install the Rattler LRF on a Picatinny/Weaver rail, perform the following
(Figure 2-6):
1. Unlock the clamping device of the scope mount by pushing down on the lever
holder (A) and unlocking the lever (B).
2. Install the scope on the Picatinny/ Weaver rail so that the stop (C) slides into
the transverse slot on the rail.
3. Affix the scope to the rail by locking the lever (B).
4. Verify that the clamping device is firmly holding the Rattler LRF. If necessary,
adjust the clamping device’s lever-cam lock as detailed in part 2.1.13
(Clamping Device Adjustment).
2.1.13 CLAMPING DEVICE ADJUSTMENT
To adjust the mount’s clamping device, do the following:
1. Remove the Rattler LRF from the weapon.
2. With the clamping device unlocked (as shown in Figure 2-6), push the cam (E)
towards the arrow, which will cause the nut (D) to slide out of its hole.
3. To tighten/ loosen the clamping device, push down on the cam (E) and turn
the nut (D) CW/ CCW respectively, in one-two increments (see note below).
Much like when the cam (E) is released, backward-moving spring will cause
the nut (D) to slide back into its hole.
NOTE:
The eight-sided nut of the mount lever-cam lock will only fit into their hole if
turned in one of the discrete positions, using increments equal to 360°/8.
4. Verify that the adjusted lever-cam lock securely holds the weapon mounting
rail.
2.2 MAIN FUNCTIONS
2.2.1 MENU OPERATION
When the device is turned on, hold the button to display the menu.
Rotate the operation wheel to move between menu items. The active element
is highlighted in orange. Press the button to select menu item or change an
option. Hold button to exit the menu.
FIGURE 2-7. THE MAIN MENU
