Pull Leg Leash Rope
through eyelet as
shown above and
below.
Pull leg cuff
through Leg Leash
Rope as shown
above.
Pull Leg Leash Rope
tight. Installation
complete.
Determine desired Paddle length. Most riders prefer Paddle
length to be 6-12 inches taller than the top of their head.
Place both thumbs on each tip of the adjusting mechanism and
slowly push forward to release pins on the pin collar.
Pull the paddle handle upwards and extend until the shaft length
is at the desired height.
The measurement notches on the shaft should be centered with
the marking notch on the pin collar.
Push the pin collar to lock the pin into place and secure the
desired height.
Paddle length can be adjusted by following same procedure.
2
3
4
5
6
Pull apart paddle shaft pieces after each use
and rinse with fresh water. Let dry and leave
apart until next use.
FIN INSTALLATION
LEASH INSTALLATION
PADDLE SIZING
*NOTE*
Fin
First remove the protective
tape, then remove the screw
from the metal plate.
Insert the screw into the fin.
Insert Fin into fin box by
inserting stainless steel pin of
Fin into the opening of fin box,
as shown above.
Push Fin down, as shown
above.
Slide Fin backwards into
position, as
shown above.
Attach Fin to metal plate with
screw, as shown above. Then
tighten screw. DO NOT OVER
TIGHTEN.
When putting the fin in for flat
water use, you can put the fin
forward. If using it in the surf,
put the fin further back in the
fin box.
Screw
Metal Plate
1
Screw
Fin
2
Fin
3
Fin
3.1
Fin
4
Fin
5
Fin
7
6
Screw
Metal Plate
We strongly suggest removing the fin when transporting the
board to prevent damage. Always screw the screw tightly back
into the metal plate on the fin box to prevent the plate from
falling out.
3.2
Alternate Insertion:
Slowly slide fin into fin box
from the top.
6”-12”
1
1
2
3
1.1
