U1701A Quick Start Guide
8
Power-On Options
To select power- on options, press and hold
while turning the ON/OFF switch to ON
position. The power- on options are listed in
:
How to Enter Setup Mode
Press and hold
and power on the instrument from OFF status. Release
when
you hear a beep, the instrument will then enter setup mode. These parameters will be
remained in the non- volatile memory even after the instrument is turned off. To
configure the related parameters on setup mode, ensure that the following procedures are
followed:
1
Press
(Left) or
(Right) to select the menu item to be set.
2
Press
(Up) or
(Down) to change the parameter.
3
Press
to select the digit to be adjusted, the selected digit will flash.
4
Press and hold
for more than 1 s to save your setting.
5
Press
for more than 1 s to exit setup mode.
Table 1-1
Power-On Options
Key
Description
HOLD
Demonstrate Annunciators
To demonstrate the annunciators, the entire annunciators will
be displayed. Press any button to exit demonstration mode.
Reset the high and low limits to factory’s default values.
RANGE
Fast power off test for factory’s purpose
REL
To view the firmware revision
SET
Setup Mode
To configure related parameter, please refer to “How To Enter
Setup Mode”.