Agilent Technologies Pump Module, Оригинальное руководство пользователя

Страница: 16 / 34

Pump Module User Guide
Setup workflow
14 Pump Module User Guide
Setup workflow
This topic describes the workflow for setting up an Agilent autofilling reservoir
or wash station on an Agilent liquid- handling device using the Pump Module.
Installing an autofilling reservoir or wash station
Auto Filling Reservoir, 96- or 384-Chimney Tip Wash Station, or Open Wash Reservoir
To install the reservoir or Tip Wash Station:
1
Place the reservoir or wash station on the platepad or shelf at the desired
location on the liquid- handling device.
Note: For the Encore Multispan System, the reservoir is installed within
the pipettable area.
2
Using a 1.5- mm hex wrench, tighten the setscrew on the platepad tab or
shelf tab to secure the container.
Step Procedure See…
1 Ensure that you are familiar with
the input and output ports for the
type of autofilling reservoir or
wash station. “Autofilling options” on page 9
2
If applicable, install the Weigh
Station or Weigh Shelf.
Note: Agilent Technologies installs
the Weigh Pad, if applicable.
•
Weigh Station . See “Installing
a Weigh Station” on page 25
•
Weigh Shelf . See the Vertical
Pipetting Station User
Guide
.
3
Install the reservoir or wash
station. “Installing an autofilling reservoir
or wash station” on page 14
4 Connect the Pump Module cables. “Connecting power and
communication” on page 15
5
Route the tubing. “Routing the tubing” on page 17
6
In the automation software,
configure the Pump Module,
reservoir, or wash station and
associated resources. User documentation for the
automation software at
www.agilent.com/chem/askb
7 Weigh Station and wash stations .
Verify the teachpoint accuracy.
User documentation for the
liquid- handling device at
www.agilent.com/chem/askb
8 Verify the autofilling function of
the completed setup by performing
a pump fill and empty task using
the automation software. User documentation for the
automation software at
www.agilent.com/chem/askb