Agilent Technologies E4400-60166, Инструкции по установке

Страница: 12 / 20

12 Installation Note E4400-90214
Removing Rear Panel Parts
1. Refer to Figure 4 on page 11. Remove the nut (not shown) that attaches the green ground wire
(A16W2) to the rear panel and remove the screws securing the line module (item 6).
2. Remove the chain screw securing the COHERANT CARRIER dust cap (item 7).
3. Remove the nut (not shown) from the COHERANT CARRIER connector (item 8) and remove the RF
connector.
4. Remove the nut (not shown) securing the serial tag (item 9) and remove the serial tag.
Assemble the Option UND Rear Panel
1. Refer to Figure 5 on page 13. Attach the A17 rear-panel interface to the Option UND rear panel
with the eight washers and hex nuts. Torque to 21 in-lbs.
2. Refer to Figure 4 on page 11. Assemble the COHERENT CARRIER connector to the rear panel
using the washer and hex nut. Torque to 21 in-lbs.
3. Attach the COHERENT CARRIER cap and chain screw to the rear panel. Torque to 9 in-lbs.
4. Insert W15 into the rear-panel hole for the BASEBAND GEN REF IN connector. Secure the cable
using a washer and hex nut. Torque to 21 in-lbs.
5. Insert W16 into the rear-panel hole for the Q-OUT connector. Secure the cable using a washer and
hex nut. Torque to 21 in-lbs.
6. Insert W17 into the rear-panel hole for the I-OUT connector. Secure the cable using a washer and
hex nut. Torque to 21 in-lbs.
7. Insert three hole plugs into the three remaining rear-panel holes.
8. Refer to Figure 4 on page 11. Reinstall the serial tag. Torque to 9 in-lbs.
9. Reinstall the line module using the two flat-head screws. Make certain that the ground plug is
pointed down. Torque to 9 in-lbs.
10. Reinstall the nut that attaches the green ground wire (A16W2) from the line module to the ground
stud on the rear panel. Torque to 9 in-lbs.