Agilent Technologies BenchBot, Инструкция по безопасности и установке

Страница: 19 / 72

9
1 Safety guidelines
Electrical hazards
BenchBot Robot Safety and Installation Guide
Electrical hazards
Hazardous-voltage electronics
Hazardous- voltage electronics can be found within the BenchBot Robot. Under
normal operating conditions, you are protected from exposure to the hazardous
voltage.
Hazardous- voltage electronics can also be found in the computer. See the
computer manufacturer documentation for the hazard warnings. Make sure you
follow the instructions on the safe operation of the computer.
Related information
WARNING
Do not try to gain access to the interior of the BenchBot Robot. Do not
remove panels for any reason. Hazardous voltage inside of the robot can cause severe
injury or death.
WARNING
Ensure that the power cord is in good condition and is not frayed. Use of a
frayed or damaged power cord can cause injury. Use only the supplied power cable. Use of
an incorrect power cord can cause damage to the robot.
WARNING
Always turn off electrical power and disconnect the power cord before
installing or servicing the robot.
For information about... See...
General safety information “General safety information” on page 2
Safety and regulatory certification “Safety and regulatory compliance” on
page 4
Emergency stop “Emergency stop” on page 6
Mechanical hazards “Mechanical hazards” on page 7
Ergonomics “Ergonomics” on page 10