Agilent Technologies 5530, Руководство по началу работы

Страница: 54 / 150

Chapter 4 Using the Agilent 5530 for the First Time
Task 3: Aligning the Optics
4-10 Getting Started Guide
4
Task 3: Aligning the Optics
In this procedure, you make sure that the optics are aligned with the laser
beam path and with each other. Follow these steps:
1 Set the turret ring on the laser head to OTHER (Figure 4-7).
Figure 4-7. Front of the laser head
2 Rotate the laser head’s target into position over the lower port by turning
the lower aperture control.
3 Pass your finger between the interferometer assembly and retroreflector.
One of the alignment dots on the laser head should flicker. This is the
retroreflector return beam. The other is the interferometer assembly
return beam.
NOTE You may need to adjust the height of the interferometer and or the
reflector to see both return beams on the target in the lower port on the
laser head.
1
Turret ring set to “Other”
2
Upper aperture control
3
Upper port
4
Lower port
5
Lower aperture control
STRAIGHT
AVOID EXPOSURE
LASER RADIATION IS
EMITTED FROM THIS APERTURE
LASER ON SIGNAL
OTHER
4
5
3
2
1
Agilent