46
8210-00001 R0
2. Make sure water can drain from the conveyor tube and intake, then wash the tube with a water hose or
pressure washer until all dirt, mud, debris, or residue is gone.
Important
Do not contact electronic controls with high pressure washer.
3. Provide sufficient time for the water to drain from the conveyor.
7.16. Repack the Wheel Bearings with Grease
1. Block wheels and ensure unit is stable.
2. Remove the wheel bolts and the wheels.
3. Clean wheel and hub mounting surfaces to ensure there is no rust or debris.
4. Remove the wheel bearing and pack with grease. Use SAE multi-purpose high-temperature grease with
extreme pressure (EP) performance. SAE multi-purpose lithium-based grease is also acceptable.
5. Tighten the wheel bolts (diagonal pattern) with a torque wrench to 100 ft-lb (±10 ft-lb) of torque. Inspect to
make sure the wheel is sitting flush with the hub.
Figure 21.
Diagonal Pattern for 4-bolt and 6-bolt Tires
1
2
3
4
1
2
3
6
4
5
7.17. Inspect and Service the Hand Winch and Lift Cable
Æ
When equipped:
Place conveyor in fully lowered position with cable slack.
1. Inspect the cable for damage such as fraying, kinking, or unwinding. Replace if damaged (see below).
2. Check to make sure cable clamps are secure.
3. Oil cable pulleys as needed.
4. Keep a film of grease on the gears. Occasionally oil the bushings, drum shaft, and ratchet.
5. Do not get oil or grease on brake discs.
6. Replace brake discs if less than 1/16" (1.6 mm) thick.
7. Check for proper ratchet pawl operation:
•
When cranking in (clockwise) = loud clicking
PTO TOP-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR
