24
The followings settings are active in the as-
delivered state:
- The switches S130 /S01 (termination for
the external S0 access) are closed and the
100 Ohm terminators are on.
- Switchable S0 access: set to external. The
switches S130 /S02 (termination for the
external S0 access) are closed and the 100
Ohm terminators are on.
- Internal phone numbers / terminal type:
11, 12, 13, telephone
- Outside line access: unlimited for all users
- Outside line seizure: "0"
- Call variant 1 (day time): no entry
- Call variant 2 (night time): no entry
- Internal call forwarding: off
- Do not disturb: off for all terminals
- Call waiting announcement prevention: off
for all terminals
- Phone number communication to the
called party and the caller: on
- Music on hold (MoH): internal on
- Automatic dialling: off
- Connection record printing: off for all
users
- Dialled phone number printing: none
- Cost limit: no entry
- Own tariff units factor: 0006
- Basic factor: 0.06
- Cleardown at cost limit: off
- Set up code: off
- Switching box code: no entry
- Busy tone on busy: off
- Communication of "0" for dialling from the
call list on the internal S0 access: off
System telephones ST 20 and ST 25
- Status display: off
- Cost display: off
- Display: English
- Call list: off
By programming on a PC, you can set the
telephone system’s functions to suit your
needs. Remote setting by your specialist
dealer is possible.
Commissioning
You have installed the telephone system.
Now, only a few operations are necessary
before you are able to make telephone
calls.
- Connect terminals. You can connect all
terminals that you are also allowed to
connect to the public
telecommunications network.
- Insert the Western plug on the ISDN
connecting cable in the
telecommunications socket (ISDN line
unit, IAE or universal line unit UAE) of
your ISDN connection.
- To avoid wrong dialling, dial a digit on an
a/b terminal with DTMF after installation.
The telephone system recognises the di-
alling method in this way.
- If you switch the dialling method on an a/b
terminal from DTMF to pulse dialling, dial
a digit higher than 2.
- If you operate two terminals on one ter-
minal connection, both of them must dial
with the same dialling method.
Notes ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
- Switch on the telephone system by in-
serting the mains plug.
- Once the telephone system has been
switched on, you can immediately make
internal and external telephone calls.
When an external subscriber calls, all
connected telephones ring according to
the telephone system's default settings
("as-delivered" settings).
- By programming on a PC, you can set
the telephone system’s functions to suit
your needs. Remote setting by your
specialist dealer is possible.
As-delivered state ¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢¢
