AgfaPhoto DV-5000Z, Руководство пользователя

Страница: 10 / 36

10
AgfaPhoto DV-5000Z
Inserting the SD memory card
If your photo/video storage will exceed the built-in memory capacity of 32MB,
then prior to using this camera you will need to load an SD memory card into
the camera.
To insert the SD memory card
1. Hold the camera with the lens facing towards
you.
2. Open the battery / SD card compartment by
pressing the cover upwards and sliding it
towards you. The cover will snap open.
3. Position the SD card so that the edge with the
gold-pin connectors faces right and gently push
the SD card in until it locks into place.
4. Close the battery / SD card compartment by
pressing the cover and sliding it away from you.
The cover will snap shut.
To remove the SD memory card
Push the edge of the SD card until it springs out from the SD memory card slot.
Then, carefully remove the SD card.
Without the SD memory card, video and photos taken will be saved to the built-
in memory of your Digital movie camera. Look at the indicator on the upper-right
of the LCD screen to see where videos and photos will be stored.
Note: Removing the SD memory card during camera operation will power
down the camera.
Operating the Camera
Turning on the Power
Install the battery and the SD memory card before turning on the Digital movie
camera. Flip open the LCD panel in a
leftwards motion then take hold of the
bottom-left corner of the LCD panel and
swivel it upwards. The Power button can be
seen on the inner top right side of your
Digital movie camera. Press and hold the
Power button for 3 seconds to turn on the
Digital movie camera. The LCD screen will
display a recording screen by default.
When the camera is on you can check the
battery power level or external power
indicator located in the bottom-left corner of
the LCD panel.
Power indicator