AGFA QCR-Z, Руководство оператора

Страница: 32 / 57

Operator Instructions
Loading Film Into The 35mm Camera
The Chinon camera allows you to take up to 36 high resolution images per roll
of film. Many of its automatic features are not needed, and the camera has
been factory-modified so that they are disabled. To load film into the camera,
power the QCR-Z on, and perform the following steps:
Locate the back cover release on the left side of the
camera. Open the back cover by pressing the release
button in, then sliding the lever downward.
• Insert the film cartridge into the chamber, and pull the film leader out
until it aligns with the yellow leader mark inside the camera.
• Lay the leading edge of the film flat along the back of the camera so that
the holes in the film fit over the sprocket teeth.
• Check that the film is properly placed and lays flat between the two guide
rails.
• Close the camera back using light pressure until it clicks shut. If the film is
loaded properly, the camera will automatically advance to frame number
one.
Figure 4-4. Loading the Chinon 35mm Camera
4-5 QCR-Z Operator's Guide Version 4