AGF Manufacturing Inc. • Phone: 610-240-4900 • Fax: 610-240-4906 • www.agfmanufacturing.com
5
Model 5100ALBV Operating Instructions
Power is supplied to the Model 5100ALBV by a 9V Battery (default) or by installing
a 12-24VDC external hard wire (See Page 6).
The 5100ALBV can draw up to
100mA during operation. Ensure the power supply is sized appropriately for
this and any other loads on the same circuit.
Battery Operation:
Remove four screws on the alarm box and take
1.
off the cover.
For battery operation, check to make sure the
2.
Voltage Jumper is on the front two pins as
shown in Image 1 (Fig. A).
Install a 9V battery as shown in Image 2.
3.
Note: When the battery begins to run low the
alarm will chirp and flash a yellow LED.
Place 9V battery under the circuit board as
4.
shown in Image 3.
Install cover with the four screws.
5.
Image 1
Image 2
Image 3
(Fig. A)
+V
-V
COM
TEMPERATURE
JUMPER
VOLTAGE
JUMPER
N.O.
N.C.
VOLTAGE
JUMPER
