3.Get into loader cli, run the following commands.
Power up the switch.
During power up press any key on the terminal to get loader CLI:
agema_ag6248c-poe ->
Follow these steps CAREFULLY:
agema_ag6248c-poe ->
setenv ipaddr 192.168.1.1
agema_ag6248c-poe ->
setenv serverip 192.168.1.5
agema_ag6248c-poe ->
tftp 20160309-onie-agema_ag6248c-poe-r0.bin
&& nand erase 0 0xa00000 && nand write $loadaddr 0 $filesize
agema_ag6248c-poe ->
nand read $loadaddr onie && nand write
$loadaddr onie2
4.Power up the switch
NOTE:
During the first boot you will see few pages of debug data. This should take
no more than a min
You should get ONIE prompt when done:
ONIE: #
