4283530M1
01-15
Field Operations and Adjustments
Front Weights
Add enough front weights to keep the tractor front wheels
on the ground at all times. Refer to the tractor Operator
Manual for Weight information about mounted and
semi-mounted implements.
Rear Wheel Weights
Add weights as required to maintain stability when
planting on hillsides and when transporting the planter.
PLANTER PREPARATION
Lubrication
Lubricate the planter as described in the Lubrication and
Maintenance Section. Also, check the fluid level in the
PTO pump. Add fluid if required.
Bolt Torque
Make sure all bolts, nuts, and screws are tight and all
cotter pins are spread.
IMPORTANT: Tighten lift wheel bolts after first day of
operation and periodically thereafter.
Tire Inflation
See the Specifications Section for the correct tire
pressure.
Seed Discs
Install the desired seed discs in all metering units.
Chains
Make sure all drive chains are installed with proper
tension, alignment, and lubrication.
Weights
Add optional weights as necessary, especially for no-till
operation. Weights can be installed on the frame or on the
lift assist wheel arms.
Seed and Transmissions
Determine the seed and chemical rates before going to
the field, if possible, and set the transmission or the seed
drive controller accordingly. Make a test run in a clear
area to verify initial settings.
NOTE: If the planter is equipped with chemical
attachment, rates will change when adjusting the
seed transmission.
Planter Monitor
Monitor and Hydraulic Drive Controls
(1)
Monitor Console
(2)
AGCO Console
(3)
Implement Switch
Mount the seed monitor console in a suitable location
near the operator. Connect the input leads of monitor to
the battery terminals.
NOTE: The monitor does not have to be mounted on the
level to operate properly.
