AGCO Glencoe CC4450, Руководство оператора

Страница: 30 / 37

OPTIONS
COULTER CUTTERS
Cutters with 22" diameter concave discs are
standard equipment. The discs cut aggressively and
mix residue with worked soil.
Rippled disc coulters 20" in diameter are available
for loosely working the soil with minimal surface
residue loss.
Disc coulter down pressure is adjusted by tightening
or loosening spring pressure. See the
ADJUSTMENTS Section.
LEVELING BAR
The leveling bar knocks down soil ridges, providing a
smoother field finish. Optional straight, spike-type
teeth can be added to the bar if desired.
Four holes allow vertical adjustment (Fig. 38). To
change, remove the clip pin and pivot pin, and
relocate as desired.
To adjust down pressure, change the chain length
between the springs and chain attachment bolt.
DEEP-TILL SHANKS
Deep-till shanks are available to replace the
standard shanks on the rear bar of rigid frame
implements only . The shanks reduce compaction
problems by shattering the soil 4" (102 mm) below
the standard chisel shanks.
The shanks are equipped with automatic reset
clamps, allowing non-stop field operation.
26
Fig. 37 - Rippled Disc Coulter Cutters
Fig. 38 - Leveling Bar
1. Vertical Adjustment Holes
2. Springs 3. Attachment Bolt
Fig. 39 - Deep-Till Shank
C445-18
32311A
C445-39
3
1
2