AGC Pro31-M, Руководство по эксплуатации и обслуживанию

Страница: 9 / 19

5
To assemble the press:
1. Place the fixed end assembly on the two 19” jack stands (see figure 6-1). The jack stands should
be located near the ends of assembly as shown. Position the two 25¾” tall jack stands as shown.
Depending on the size frame you are assembling the actual distance from the fixed end will vary.
These stands will support the rails and should be located so they are opposite from the rail holes
in the fixed end.
2. The Pro31 uses two different length bolts to secure the rails. Each press requires 8 (eight) rail
bolts. Four each 1¼-12 x 8” long and four 1¼-12 x 7” long.
3. To attach the rails to the fixed end use the four 8” long bolts, 4 each 1¼” flat washers, and 4 each
1¼” lock washers. Prior to installation, apply a liberal amount of food grade anti-seize to the
threads of each bolt.
4. Position the bottom rail as shown in figure 6-2. Loosely bolt the bottom rail in place. It may be
necessary to adjust the rail to install the end support.
5. Position the upper rail as shown in figure 6-3 (hanger side toward the bottom rail) and loosely bolt
the rail in place. Note: The bolts will be fully tightened after the end support is installed.
6. Using a forklift truck, carefully position the end support assembly at the end of the rails as shown
in figure 6-5. It will be necessary to remove the upper and lower covers on the end support to gain
access to the rail bolts. Install the rail bolts and washers to attach the end support to the rails.
Figure 6-1 Figure 6-2
Fixed End on 19” Tall Stands Fixed End with Bottom Rail