This screen shows that the ovens will be up at ‘Normal’ temperature between 07:00 and 10:00, the ovens will then go to
‘Low’ mode.
The ovens will come up to ‘Normal’ once more in that day i.e. at 16:00 until 19:00. After the evening, the system will
automatically enter ‘Slumber’ mode, its lowest setting until the next morning.
Boost
If cooking is required when the Aga is in the
AIMS
program i.e ‘Low’ or ‘Slumber’, you can boost the cooking
temperature by pressing the Button which will bring the AGA upto ‘Normal’ operating temperature. This will take up
to 2 hours from ‘Low’ and 4 hours from ‘Slumber’.
AIMS PROGRAMME SCREEN
2
1
4
3
Fig. 20
DESN 515274
20
Use the button to activate this screen and to move through the different actions
and set an AIMS programme. To go back a step at any time press .
2
3
4
1. Set the frequency of the programme Once or Twice daily using + and - buttons.
2. Press button to select start time for ‘Normal’ setting then use the + or - buttons to set start time.
3. Press the button to select finish time then use + and - buttons to set finish time. When a time is
selected it will be highlighted in dark blue.
4. Press the button then press the button to alter the temperature setting to ‘Low’, ‘Slumber’, or ‘Off’.
(Repeat steps 2 - 4 to set a 2nd event)
To copy this days settings for the next day press the button or alternatively press the button to enter
different settings for next day.
Each push of the copy button steps onto next day. When the desired days have been programmed a return
must be made to the main menu screen by pressing the button. A ‘
Please Wait
’ message will display to
confirm changes are being sent to the base unit.
If the programme is not set for the whole week the programme for the remaining days will revert to a
default setting. ie: 8:00 am - 9:00 am and 18:00 - 19:00.
To change a setting within the AIMS program, press the button until the desired setting is reached.
Then change setting using either the +, - or buttons as appropriate.
If no other changes are to be made, push the button to transmit the change (s) and return to main
menu. A message saying ‘
Sent OK
’ will display, indicating that the changes are being transmitted to the
base unit. Unless this shows, the changes will not have been implemented.
