AGA 13 AMP RETRO-FIT WITH AIMS, Инструкция пользователя, Страница: 15 / 20

15
Operating Distance
The Handset will only operate in the same room as the appliance and up to a maximum distance of 4 metres from the
appliance. If out of recommended operating range, the handset may show “OFFLINE”. Move handset back to within the
recommended distance and the handset should correct itself. See note at foot of page for “Handset to Base Unit Signal
Check”.
Cleaning
The Handset should be wiped clean using a soft clean cloth.
Do not use abrasive cleaning products or submerge the Handset in water.
Batteries
The Handset is fitted with four 'AAA' batteries.
Batteries life will depend on usages.
Replace the batteries when the battery symbol on the Handset is down to one bar following the instructions below.
-
Remove the Handset from the backplate.
- Remove the battery cover plate from the rear of the Handset (Fig. 10)
- Carefully lever out the batteries commencing with the bottom one first pushing and pulling out on the positive (+) end
only (Fig. 11).
- Repeat the procedure to remove the other batteries.
- Always use long life batteries for replacements.
- Replace batteries commencing with the bottom one working to the top (Fig. 12) Ensure that the negative (-) end of
the batteries is under the location pegs in the housing before pushing the other end into position.
Handset Failure
In the event of Handset failure, the appliance would still be operational with the last selected programme. The appliance
can also be changed to manual mode if required using the control knob (See Fig. 4).
If the Handset is damaged or lost, replacement can be obtained from Aga and re-programmed to suit your appliance.
Handset to Base Unit Signal Check/Language Selection
Complete the following procedure to check the handset is communicating with the base unit and to select a language
option.
1. Press and hold the oven vent fan button on the control panel in the Aga until the blue neon vent fan indicator flashes,
then release button.
2. Immediately after neon starts to flash press and hold the + and - buttons together on the handset until the blue neon
goes out completely (handset display will briefly say connect), then release buttons.
3. If the neon does not extinguish completely, but continues to flash with a faint output, then repeat steps 1 and 2 above.
4. When the connection has been made, the screen will display the language options, use the + or - buttons to scroll
through the options to the desired language, then press the button to confirm selection.
5. If the language options needs to be changed at any time then the whole procedure must be repeated from step 1.
AIMS HANDSET CARE
Fig. 10 Fig. 12 Fig. 11