Cleaning and Maintaining Your Wine Chiller
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements,
additions, replacements or compensation for previously purchased products.
6
Condenser
The condenser tubing inside the cabinet does not require
frequent cleaning; however, satisfactory cooling depends
on adequate ventilation over the coils. Be sure that nothing
obstructs the required air flow openings in front of the
cabinet. At least once or twice a year brush or vacuum lint
and dirt from the grille. Also at least once or twice a year
brush or vacuum lint and dirt from the condenser for
efficient performance by unscrewing the grille on the
bottom front of the cabinet.
Cabinet
The painted cabinet can be washed with mild soap and
water and thoroughly rinsed with clear water. Never use
abrasive scouring powders.
Interior
Wash interior compartment with mild soap and water. Do
not use an abrasive powder, solvent, polish cleaner or
undiluted detergent.
Glass Door
Use a glass cleaner or mild soap and water and soft cloth
to clean the glass door model. Do not use any abrasive
powders.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water,
a baking soda solution or a mild scouring powder.
Light Tube Replacement
WARNING! DISCONNECT THE POWER CORD BEFORE
ATTEMPTING LIGHT TUBE REPLACEMENT. Failure to do
so may result in an electrical shock that could severely
injure you.
This product uses two, 6 watt light tubes to illuminate the
interior of the wine chiller. The light tubes are very reliable
electrical components, but should either or both light
tubes not function properly, please call the dealer you
purchased your wine chiller from for replacement light
tubes. Use only original equipment light tubes from your
dealer or manufacturer.
Light tube replacement consists of using a small cross head
screwdriver to remove the two screws that hold a cover
plate over the back section of the light tube. Set the screws
and cover plate aside for re-assembly later.
Using a small flat-blade screwdriver, gently lever the front
section of the light tube down to allow it to be pulled clear
of the light housing.
Disconnect the two insulated electrical connectors from
the cabinet’s electrical cable and discard the old light tube.
Reconnect the insulated electrical connector of the new
light tube to the cabinet’s electrical cable connectors.
Make sure they are secure and fully inserted.
Carefully realign the light tube’s electrical terminals back
into the rear of the light enclosure channel making sure
not to crimp them. Gently insert the light tube along the
length of the light enclosure channel. Press the light tube
gently into the light enclosure channel. Only a small part of
the light tube should project below the ceiling of the wine
chiller. DO NOT USE A HAMMER TO FIT THE LIGHT
TUBE.
Place the light tube terminal cover plate back in its original
position on the light enclosure’s flange. Re-use the original
two screws to secure it in place. Plug the wine chiller into
the electrical socket. Check to see if the light tubes operate
properly. Your light tube’s replacement is complete.
The light tubes are not covered by your guarantee.
Replacement tubes can be obtained from your service
provider or from Aga Appliances.
Light Tube
Connectors
Cover Plate
Screws