AGA 100/3, Руководство пользователя и инструкции по установке

Страница: 40 / 48

36
The method of connection to the mains electricity supply
must facilitate complete electrical isolation of the appliance,
by a multi-pole switch, having a contact separation of at least
3 mm on all poles.
The isolator should not be positioned immediately above the
cooker, but must be fitted within 2 metres of the appliance.
The isolator maybe separate from the connection point.
The mains connection point must be accessible within the
areas shown in
Fig. 14.1
and
Fig. 14.2
for cable routing
options.
Induction Hob
An additional, seperate single phase power supply is
required. 230V ~ 50 Hz, 13 amp fused electrical supply.
14. Electrical connection
SECURE MAINS CABLE USING ‘P’ CLIPS FOR LEFT HAND OR RIGHT HAND CABLE MANAGEMENT.
THE MAINS SUPPLY MUST BE WITHIN THE ZONES SHOWN. IF A RECESSED
COOKER CONNECTION IS TO BE USED BEHIND THE APPLIANCE WITHIN THE
HATCHED AREA ALLOW A 5mm GAP AT REAR OF APPLIANCE.
450mm MA
X
2 metr
es 2 me
tres
WORKTOP
WORKTOP
Fig. 14.1
Fig. 14.2
DESN 517652
DESN 517651
NOTE
: If timer kit is fitted use the cable tie provided in timer
kit to secure timer cable to mains cable.
n n
WARNING: This appliance must be earthed.
n n
This appliance is designed for the voltage stated on
the rating plate, which is situated behind the plinth
cover.
n n
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified person to avoid a hazard.
For the cooker
A 1PH 32 amp 230V ~ 50 Hz fused electrical supply is required
adjacent to the appliance. External wiring to the unit must
be installed using the mains cable provided, in accordance
with the current wiring regulations and any local regulations
which apply. If the cable is shortened, new ferrules must be
fitted to the stripped conductors.