AG SPRAY 5303228, Руководство пользователя

Страница: 4 / 14

Page 4
There is a valve on the intake line. It is at this location so
you can shut off the flow of solution to access your
system’s filter screen for cleaning.
Checking/Cleaning the sprayer’s filter/screen:

Start your pump and before it shuts off, reach down
and shut the valve to the ‘Closed’ position, then shut
off your pump.

Unscrew the bowl of the filter to access the screen.

Remove the screen and clean as necessary. Replace when done and reassemble the entire assembly.

Make sure the valve is turned to the ‘Open’ position before restarting your pump.
PRO SERIES Long Range Ergonomic Handguns
Technical Specifications:
• Adjustable Spray Pattern • Aluminum Barrel • No Drip Shut Off
• Convenient Hanger Hole • Integrated Trigger Lock • 600 PSI, 8 GPM
• Chemical Resistant Construction
• 38’ Horizontal, 27’ Vertical Maximum Spray Distance
• Adjustable On/Off Trigger Stop for Precise Spray Pattern
To adjust the spray pattern, the nut needs to be adjusted (Ref. A). Spinning it off, towards the
lever, will make a cone pattern and spinning it on, away from the lever, will make a stream.
The lever (Ref. B), is the lock that can be used to lock the lever when pulled, holding the
valve open. Squeezing the trigger, will release the lock.
Winter Storage
Prepare the sprayer for end-of-season storage by running RV antifreeze through the system. This will keep internal parts
lubricated, protect against corrosion and keep the unit from freezing. Note: RV antifreeze is non-toxic and biodegradable
and generally safer for the environment than automotive antifreeze.
Before storing your sprayer for winter or long term storage,
thoroughly clean and drain it as much as possible. Then pour enough pink RV antifreeze into the tank so that when the
pump is turned on you can pump the antifreeze throughout the entire plumbing system, including the bypass.
Make sure to operate the boom (if applicable) and handgun until you see pink fluid spraying from the nozzles. Leave any
remaining antifreeze in the tank. Before your next usage, rinse the antifreeze from the sprayer with clean water.
It is nearly impossible to drain all of the water from the sprayer and any trapped water can freeze in cold weather and
damage parts of the sprayer. Pumping the antifreeze through the system will displace the water and help prevent this
damage.
Removing from storage: drain the antifreeze. Fill the tank with fresh water and run through the system. Dispose of anti-
freeze and flush water properly.
Removing the pump from the sprayer and storing it in a heated area will also prevent costly damage to the pump. This
should be done AFTER the pump has been neutralized and flushed out with RV antifreeze. Plug the inlet and outlet ports
if storing inside.