INTRODUCTION
The HIP-Series, HDMI extender set is designed to extend your HD display with the resolutions of
1080p/60Hz up to 330 feet (100 meters) away from your HDMI or DVI-D source. Thanks to the use of
the TCP/IP protocol, you can transfer your high-definition video over an existing TCP/IP network. See
below three examples:
A: The Tx and Rx units can extend 100 meters over a single CAT5/6 cable connection point to
point.
B: The Tx can be connected to a Gigabit switch to establish a IP address therefore sending
1080p video signals to multiple Rx connected to the Gigabit switch and the HDMI displays.
C: Multiple Tx’s can be connected to a Managed Gigabit switch with VLAN/IGMP support
therefore sending 1080p video signals to Rx connected to the Gigabit switch to show different
sources on the HDMI displays.
• Extends HDMI up to 95m/100m over single CAT5E/6
• Supports HDMI, EDID, Support HDCP
• Supports resolution HDTV / 1080Pp/60Hz, Vesa (1920 x 1080)
• Supporting the point to point transmission function currently which can be expanded to the
multi-point to point transmission function.
• Requires a managed Gigabit switch with VLAN/IGMP support to have a soultion with multiple
sources (Transmitters). Standard Gigabit switch can only support one transmitter.
• The managed switch must support port based IEEE 802.1Q VLAN, IGMP, and to allow
duplicate IP addresses across the VLAN domains.
• Each VLAN acts as independent HDMI over IP Channel on the network.
• Number of Tx and Rx that can be used is dependent on bandwidth of the switch
(Recommended Gigabit switch 10/1000).
• Managed switches can be cascaded up to 3 levels, allowing the farthest display to be located
up to 300 meters away from the source device. Each receiver can be located up to 100 meters
away.
• Uses M-JPEG technology to process image compression on a fixed bandwidth.
3
