7
CONTROL PANEL + MAINTENANCE
HUMIDITY CONTROL
The desired humidity could be changed by pressing UP or DOWN keys to set or adjust humidity by 1%
increments in the range between 26% and 90%. When the environmental humidity is below 26% “CO” will
be displayed. Press and hold the UP or DOWN key to increase/decrease the desired humidity level by 5%
per second.
KEY LOCK
If “T” and “P” are pressed simultaneously for 2s, the defrost light will blink and all the keys on the control
panel will lock. Unlock the Control Panel by repeating the same action a second time.
MANUAL DRAINAGE
Press “P” to manually empty water from the pump reservoir before moving the machine to avoid water
spillage. During normal operation the pump purges automatically when the reservoir is full. Manual drain
will last for 3 minutes (180 seconds).
DEFROST INDICATOR
The unit begins to defrost automatically as needed when the defrost indicator lights up; the unit stops
defrosting when the defrost indicator is off. When defrosting finishes, the unit continues to dehumidify
automatically.
MAINTENANCE
Frequent maintenance is recommended on this appliance. Failure to follow the maintenance instructions
may cause failure of the appliance and void the warranty.
Before maintenance or storage, you should always:
10. Process a drainage manually.
11. Disconnect the machine from the power source.
12. Remove the drain hose.
BEFORE USE
1. Check the power cord for signs of damage such as fraying. Repair the cord before use if there is any
damage.
2.
Check the filter for signs of dirt or obstructions. Clean or replace the filter as necessary.
3. Check the coils for signs of buildup. Clean if needed.
