© Copyright LOTRONIC 2016 PARCOB50WH / PARCOB150WH
Page 3
2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of the slave light. Connect
the DIGITAL OUT socket of the master and the IN socket of the slave light, then, connect the OUT socket to the IN socket of
the next light. Ordinal to connect all the lights as below:
IN
O U T
IN
O U T
O U T
IN
1
2
3
D
M
X
IN
DM
X O
UT
The connection between the output of master and input of product, it’s available to use the 3 pins XLR cable which provided
by the manufacturer. Signal cable from the DMX output of the controller to the input of the first master light, and connect to
the DMX input of second slave light from the DMX output of the first master light, analogously, till connected all the slave
lights, and insert the last connector to the output of the final light. (Notice: the diameter of core of every cable should be
0.5mm at least, double core shelter cable should be used).The signal connecting must use the attached 3 pins XLR cable.
Notice, all the internal lead wire of the 3 pins XLR cable should not touch to each other or connect to the connector.
A DMX signal terminator is recommended on the last unit of the ch
ain. DMX terminator is a XLR connector with a 120Ω
resistor between the pin 2 and pin 3 of the XLR connector
RIGGING
This fixture may be mounted in any position, provided there is adequate room for ventilation
It is important never to obstruct the fan or vents pathway.
When selecting installation location, take into consideration lamp replacement access and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted
ventilation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his
service agent or a similar qualified person in order to avoid a hazard.
Features
•
4 channel DMX-512
•
Variable electronic strobe.
•
Variable electronic dimmer (0-100%)
•
Digital LED display
•
Reset to factory settings option.
•
Color temperature setting
•
Build-in program with speed adjustment
•
Fan cooled.
OPERATION
After you connected the effect to the mains, the fixture starts running.
Stand Alone operation
In the stand alone mode, the fixture can be use without controller
Master/slave-operation
The master/slave-operation allows several devices to be synchronized and controlled by one master-device
DMX controlled operation
You can control the projectors individually via your DMX-controller
