14/21
Part 4: Assembling the Plastic Sheet
Assemble the plastic sheet onto: Top, Side and Bottom Beams, side rails as shown below.
1.
Assembly
the sun shield to the
wind shield with a
connection HP2 profile, upon
a flat table or box.
Make sure that the HP2
profile SUN direction is UP.
Slip in the sheet in to the HP2
lips by pressing down and
shoving it in.
Note
: pre peel off a 100mm
(4`) of the protection film
around the edge contours to
avoid catching.
2.
Secure the sheets together
by cello taping it on the
upper side.
Insert a leftover plastic
between the tape and the
HP2 profile.
Stick the rubber strip
ACS4005
as shown, on the
rear edge apply it on both
upper and bottom side.
Make sure that ACS4005
sticks
upon the plastic
sheet
without protection film.
Note
: avoid contact between
adhesive cello tape and
unprotected plastics.
