AFI-1000 and AFI-2000 Heavy-Duty Waterproof Wiper Motors
The AFI-1000 and AFI-2000 offer the following features:
Full three-year warranty
Extra heavy-duty motors and magnets
Fully sealed waterproof housing
U.V. stabilized, high impact thermoplastic
Standard 5/8” diameter, anti-rotation knurled drive shaft and
solid brass arm drive nut
Adjustable self-parking
AFI-1000 measures 6-
5/8” L x 3-3/8” W x 2” H
AFI-2000 measures 7-
3/4” L x 3-7/8” W x 2-3/8” H
AFI-
1000 pulls up to a 16” arm and 16” blade combination
AFI-
2000 pulls up to a 24” arm and 24” blade combination
AFI-1000 has adjustable sweep settings of 50°, 65°, 80°, and
110°
AFI-2000 has adjustable sweep settings of 45°, 60°, 80°, and
110°
NOTE: Please Read All Instructions Before Starting
TOOLS NEEDED
7/32” Drill Bit For Through
Hole Mounting
5/32” Drill Bit For Self-
Tapping Screw
Drill
On/Off Switch
5/8” Drill Bit (16 mm)
Phillips Head Screwdriver
1/2” Round File
Safety Glasses
3/4” Open End Box Wrench
16 Gauge Wire
Quick-Connect Tabs
Measuring Tape
Marine Grade Caulk Or
Silicone
MOUNTING PRECAUTIONS
1.
Mount wiper motor on a flat surface. Failure to do so may
crack the housing when securing.
2.
For optimum performance, keep the wiper shaft 90° to the
windshield.
3.
Blade and arm should be installed approximately 1” (25.4 mm)
minimum away from windshield molding. Energize the motor
for short intervals to make certain the wiper blade does not
strike at either end of the wiping arc. If blade strikes at both
ends, it will be necessary to shorten the arm and blade length
and/or reduce the sweep angle.
MOUNTING & WIRING
1.
Locate proper mounting position of wiper assembly, and
determine whether adequate space is available.
2.
Drill wiper shaft hole first, using a 5/8” drill. It may be
necessary to enlarge the 5/8” hole slightly with a file to facilitate
ease of installation.
3.
Use motor as a template to drill hole for mounting bracket. A
no. 10 size screw is recommended.
4.
Before mounting, connect wiring to wiper motor (see diagram).
NOTE:
If the motor is installed in a location exposed to
moisture, fill in the wiring cavity with marine grade caulk
or silicone after making the electrical connections in order
to prevent terminal electrolytic corrosion.
5.
The wiper motor may now be placed in position and the wiper
shaft attaching nut and washers installed. This nut should be
tightened no more than 30 to 45 in-lbs.
6.
The mounting bracket screw should be attached at no more
than 15 in-lbs. Do not over tighten.
MOUNTING DIAGRAM
WIRING DIAGRAMS
ONE WIPER TO ONE SWITCH
TWO WIPERS TO ONE SWITCH
TERMINALS
WIRING CAVITY
