2014 AFG Baby Furniture W3358 Assembly Sheet
10
C3358
Changer Wall Safety Strap
WARNING: WHEN UPRIGHT, IT IS POSSIBLE THAT THE FURNITURE MAY TIP OVER.
FOR YOUR CHILD’S SAFETY, PLEASE INSTALL THE SAFETY WALL STRAP BEHIND
THE FURNITURE.
•
TOOLS NECESSARY: RUBBER MALLET, PHILLIPS SCREW DRIVER.
•
TOOLS AND HARDWARE SHOWN ARE NOT INCLUDED.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT AND KEEP
THESE INSTRUCTIONS FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, PLEASE
EMAIL US AT:
Safety Wall Strap 8” x 1.5” (1 pc)
Washer (2 pcs)
Screw D4 x 1-3/8” (1 pc)
Screw D4 x 3/4” (1 pc)
Wall Stud (1 pc)
STEP 1
: Make a mark near the top of the back
side of the furniture (in the center toward the top
frame of the furniture of where you would like to
install the safety wall strap). Insert the short screw
through the washer and through the safety wall
strap. Install the screw into where the mark was
made behind the furniture using a Phillips screw
driver
STEP 2
: Locate a wall stud. With the back of the
furniture against the wall, locate the middle of the
top of the dresser and make a mark against the
wall. Measure 5cm down from the mark and drill a
1/8” pilot hole through the wall stud and into the
plaster wall.
CAUTION
: The changer unit must be centered on
a wall stud as shown. If you are unsure of how to
locate the wall stud, contact a professional
contractor.
Wall Stud
STEP 3
: Attach the wall strap to the wall stud
using the long 1-1/2” screw and washer as shown.
Make sure strap holds steady and complete
installation.
CAUTION
: Do not attempt to screw into the
plaster wall only. You must screw into a wall stud.
