16
IRMT-4 Aeware instructions
learning mode
The learning operation is
initiated as follows:
1• Press and hold
setup
until
LED blinks twice to initiate
Learning mode, then release
key.
2• Enter
9-7-5
. LED will blink
twice. Remember to press
and hold
shift
key first to
access numbers (
0-9
).
Note:
To optimize success, the learning process should be conducted
in an area where there is a low level of IR emission. High levels of
natural light or energy efficient fluorescent lights could interfere
with a learning event. The source and target (IRMT-4 Aeware)
remotes should be no more than 1 to 2 inches apart during a learn-
ing event and the IR LEDs of the two units should be aligned with
each other.
It is important to use new batteries on the source remote. (Refer to
following page to read limitations about the Learning mode.)
The IRMT-4 has the ability to learn new functions
from your original remote controls.
1" to 2"
