ACUO 908 Serie - AEV ON AIR CONSOLE
AEV Broadcast Srl
, via della Tecnica 33 – 40050 Argelato (BO) Italy
Web site www.aev.eu e-mail [email protected]
15
Logic GPI/O port
•
GPO 1 Out ( Start / Stop A)
through the encoder master to the voice GPIO1 (Start
/ Stop A) select the channel assignment, so when the channel will in Start, the
contact between 1 and 9 will close, with the channel in Stop the contact is open .
•
GPO 2 Out ( Start / Stop B )
through the Master encoder select GPIO2 (Start /
Stop B) and select the channel assignment, so when the channel will put in Start,
the contact between 2 and 10 will close , with the channel put in Stop the contact is
open.
•
GPO Tally
: Endcoder in each channel, through the Encoder, to the item TALLY set
ON , so closes the contact between pins 3 and 11 will close when the channel is put
in Start
•
GPO 3
: Endcoder by the Master, under GPO3 select the channel assignment , so,
the contact between pins 4 and 12 will close when the channel will put in Start in,
the contact will open when you put in Stop the channel.
•
GPI 1 ( In Start/Stop A)
: through the Master encoder select
GPIO1 (Start/Stop
A)
and select the channel assignment, in which way , from the outside, through a
circuit to activate the photo - coupler placed between the pins 5 and 13, states Start
and Stop will alternate in the channel , the status of which will be remote using the
control
Out Start/Stop A
•
GPI 2 ( In Start/Stop B )
through the Master encoder select
GPIO2 (Start/Stop
B)
and select the channel assignment, in which way , from the outside, through a
circuit to activate the photo - coupler place between pins 5:13 states will alternate
start and stop of the channel , the status of which will be using the remote control
Out Start/Stop A
