Chapter 6
INFORMATION ON USE
-
30
-
English
C62
4146
000.fm
ID
M
6.11. STARTING AND STOPPING THE CYCLE
For this operation, proceed in the follow-
ing way.
1 -Position the load on the rotating ta-
ble and remove the loading device.
2 -Block the edge of the film in the
clasping disk on the rotating table.
3 -Press the "Cycle start" push-button
(A)
. The machine performs a cycle
and stops automatically.
4 -Cut the film.
5 -Remove the load and place another
one on the table to start a new cycle.
Information
To pause the cycle, press the "Stop
cycle" (B) button; press the "Start cycle" button
(A) to restart.
Remote control (optional)
: to start and
stop the wrapping cycle by remote con-
trol.
1 -Press "Start" to start the cycle.
2 -Press "Stop" to stop the cycle.
6.12. EMERGENCY STOP AND RESTART
Turn the main switch to 0 (OFF) in im-
pending risk conditions. Machine opera-
tions stop immediately.
After having normalized work condi-
tions, release the button to allow opera-
tions to restart.
To restart the machine, act as follows.
1 -Press the "Reset" button to reset
the machine.
2 -Repeat all the automatic cycle start
operations (see § 6.11.).
A
B
IDM-24128801200.tif
IDM-227044.tif
IDM-24128603200.tif