AETNAGROUP Robopac Rotoplat 3000LD, Инструкция по эксплуатации

Страница: 16 / 87

F
2
9102
6101
.fm
IDM
English
4
Use and maintenance manual
Booklet
2
Basic MACHINE ASSEMBLY
2
WORKING CYCLE
6
The machine work cycle consists of phases that are illustrated and described below.
For further information please consult the booklets on the installed functional units.
–
Phase 1 : conveyor unit (A) conveys the pallet on the rollers of rotating table (B) .
When the sensor detects that the pallet is in the middle of the winding area, rollers of
the rotating table stop.
–
Phase 2 : the rotating table (B) starts and begins wrapping. Simultaneously, the
spool carriage (C) pre-stretches film. At the end of the first wrap, the clamp (D) releas-
es the film edge. The spool carriage starts to lift, wraps the load and create a spiral
wrap. When fully lifted, detected by a sensor, the carriage lowers and performs a sec-
ond wrap. When finished the rotating table stops.
–
Phase 3 : clamp (D) closes and holds the edge of the film for the next wrapping cycle.
unit (E) cuts the film.
–
Phase 4 : the roller conveyor transfers the pallet to the outfeed conveyor (F) . This is
where cycle ends and a new one starts.
SAFETY DEVICE DESCRIPTIONS
7
The figure shows the positioning of the devices on board of the machine.
A –
Main switch (lockable) : turns the main power supply on and off.
It can be locked to prevent access by unauthorised personnel during machine adjust-
ments and maintenance.
B –
Emergency stop button : immediately stops the machine in the event of imminent
risk. It must be reset to restart the work cycle
C –
Fixed safety guard: outer structure to prevent the operator from accessing the
operating area during the execution of the operating cycle.
IDM-29145200200.tif
Product inlet area Product winding
area
Product outlet area
(A) Conveyor unit
(F) Conveyor unit
(C) Spool carriage unit:
(B) Rotating table
(E) Cutting unit
(D) Clamp unit