LEDs
PoE
Yellow ON
PoE: Power port is connected to PD
LAN
Green flash
LAN: Data is being transmitted or received.
OFF
No connection
PWR
Yellow ON
Power adapter is connected the EPoT adapter
LINK
Green ON
Rx and Tx EPoT adapter is connected.
DIP Switch
DIP#
On
Delivery PoE output to PD device
Off
No PoE output to PD device
NOTE:The PoE On/Off switch is only available on TE10-110-TX / TE12-120-TX
/ TE22-110-TX
/
TE22-120-TX
Distance/Power Chart
NOTE:
1. The number comply using 4 pair Cat6 cables.
2. The length of network cable for camera connection is 1m Cat6 cable.
3. The power delivery will vary on the quality of Cat6 cable due to
resistance.
AETEK INC.
3F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C.
|
T
:
+886-2-82452822
|
W
:
www.aetektec.com
|
E
:
All specifications are subject to change without noice.
Copyright © 2018 AETEK INC. All rights reserved.
To disconnect a LAN cable, loosen the cable
gland and pull the cable against the socket
wall towards the side of the locking tab.
Outdoor LAN Port
IMPORTANT -
please follow the procedures below carefully to ensure the best seal:
1. Fit a RJ45 plug to the Cat5e/6 cable
2. Thread the Cat5e/6 cable through the cap(A) & grip(B)
3. Split rubber(C), rubber have two sizes for meet 4.5~6.5mm Cat5e/6 cable.
4. Fit the split rubber(C) over the Cat5e/6 cable
5. Thread the Cat5e/6 cable through the body(D)
6. Fit the washer(E) to the TE22-110-TX/TE22-120-TX connector
7. Plug the RJ45 connector on the Cat5e/6 cable into the TE22-110-TX/
TE22-120-TX
8. Hold TE22-110-TX/TE22-120-TX and then screw the body(D) onto the
TE22-110-TX/TE22-120-TX connector tighten firmly
9. Push rubber(C) in the grip(B) and screw the cap tighten firmly. The
Cat5e/6 cable is sealed when the rubber(C) & grip(B) bulges to the edge
of the cap(A).
Outdoor 4 Pair LINK Port Connector Assembly
Washer (E)
Body (D)
Rubber (C)
Grip (B)
Cap (A)
Rubber (C)
Rubber (C)
Split
Length of Coaxial Cable
300m
34.72W
500m
25.2W
800m
13.11W
1000m
10W
1200m
9.66W
1200m ~ 2400m
Data only (100Mbps)
