V1
Page 6
Adding a service number
This is important for Pay & Go or Pre-Pay SIM cards. Many networks will de-activate a SIM
card if it does not make a chargeable call every so often. To get around this problem, this
unit can be programmed with a service number which it will call every 30 days. You can
have it call the home owner, or the engineer’s phone, or to avoid a nuisance call from it once
per month, it could instead be programmed to call a talking clock number in your country.
77
0123456789
#
Parameter
Telephone
number
You may test the caller ID feature by calling the device from a phone which has been stored.
The unit should ring only once or twice, hand up and trigger the relay. The relay is default for
a 1 second momentary click. If you need to change this, please refer to the full programming
table.
6. Installing
The enclosure is IP67 weather proof rated, and for best reception, the device should be
installed outdoors, high off the ground, away from metal objects and shrubs.
If you are using this for a barrier control, then you MUST use an external antenna OUTSIDE
the barrier enclosure, as the unit will not have reception otherwise.
Entrance Pillar
Use an external antenna on an
extension cable if reception is
poor.
Keep
away
from
ground.
i-gate 100
Connect the N/O and COM of the output relay on the device to the Start command and
common of your gate / barrier controller PCB
770987654321#
Add a service number
success
Below is an example. Use 77 feature to
add a service number (no passcode
needed)
…