V1
Page 11
12.Using the device as an Alarm Dialler
The Same SMS commands used in the previous section to control automatic gates can also
be used to larch on, latch off or trigger the alarm in various ways, depending on how it is
installed.
The user may also use the control command *22# to check the status of the output in the
event that the output is being used to arm or disarm the device.
If the device is being used as an alarm dialler, it will call 3
telephone numbers when the alarm is activated. If any
number answers the call, then it will not call the next
number.
Each number will be called only once.
If the system has been installed in such a way to allow the
output relay to control lights or disarm the unit, then the
user can press * to momentary trigger the output, # to
latch it on, or 1 to unlatch it.
