9
Cleaning the ActivePure Cells
Remove the ActivePure
®
Cells and carefully vacuum accumulated lint. Do not wash the ActivePure Cells. Damage from water may result.
Filter Assembly Cleaning
1.
When visibly dirty, simply remove the Rear Filter Assembly from the unit (see page 8), and with a hand-held vacuum, remove the heavy
particulate. This method will extend the life of the Filter Assembly.
2. If the Filter Assembly can’t be cleaned by vacuuming, replace the Filter Assembly.
Filter Assembly Replacement
Contact your Independent Distributor/Contractor or Aerus
®
Customer Service at 800.572.0502 (U.S.) or 800.668.0763 (CANADA) for
replacement filters (see pages 8 – 9 for removal and installation instructions).
NOTE:
Filter Assembly life will vary based on the operating environment.
Changing the ActivePure Cell
The ActivePure Cell should be replaced when REPLACE ACTIVEPURE CELL appears on the display, or twelve (12) months when used
continuously To change the ActivePure Cell, follow the instructions on page 10.
GENERAL MAINTENANCE (CONTINUED)
REMOVING THE FILTER ASSEMBLY
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the Aerus Pure & Clean without the Filter Assembly and Back Cover properly installed
Hand Strap
1.
Unplug unit
2. Press the top of
the back cover to
release the back
panel
3. Lift up to remove
the back panel
4. Use the included
screwdriver to
unscrew the Filter
Assembly
5. Lift the Filter
Assembly up and
out to remove
