6
GETTING STARTED
NOTE: Before using your purifier/humidifier,
remove all packaging from the filters.
WARNING:
Disconnect plug from power source!
Step 1:
Open the front panel. To do this, hold the top of
the front panel on the upper left- and right hand
side of the front panel with both hands, then pull
the panel towards you until it is fully removed
from the main body of the unit.
Step 2:
Remove the Pre-Filter, HEPA Filter and Activated
Carbon Filter from the unit. Completely remove
all of the packaging from each filter.
Step 3:
Insert the filters back into the filter cavity in this
order:
1. Insert the Activated Carbon Filter, front side
facing out.
2. Insert the HEPA filter, front side facing out.
3. Insert the Pre-Filter by bowing slightly and
inserting Tabs into one side and then into
the other side.
Step 4:
Reinsert and close the front panel. Do this by
inserting the lower part of the front panel into
the two bottom holes on the unit (see drawing
1 below) and raise the lid upwards until it closes.
The front panel is secured with magnets
(see drawing 2 below).
DRAWING 1
DRAWING 2
