Step 6:
Match the receiver and transmitter. First, turn the
transmitter on by pressing the two buttons on the right side of
the transmitter simultaneously until the screen is turned on.
Choose a dog mode (Dog1, dog2 or dog00) by pressing the dog
switch button. For the first receiver, choose dog 1 mode and
quickly press one of the three buttons in the front, and the first
receiver will be connected with the transmitter. Meanwhile,
the red light goes off and the blue light starts flashing. If you
have another receiver, turn it on, choose dog 2 mode, press any
function buttons, and the second receiver will be paired. You can
train different dogs separately in different dog systems. If Dog00
is selected, both dogs will receive correctional signals.
Step 9:
Start to train the dogs. Put the collar into the receiver and
wear the receiver around dog's neck. Remember to leave one finger
place between the collar and the neck, and then you can train the dogs.
Quick Start
-03-
02
01
00
ON
ON
dog switch button
Vibrate button
Beep button
Shock button
Tip 5: The duration for pressing the beep, vibrate or shock button will
lead to difference on the length of the beep, vibration or shock time.
Step 8:
Adjust the intensity of the shock.
There are 2 buttons on the transmitter's right
side: Up button and Down button. The Up
button is to increase while the Down button is
to decrease the intensity of the shock. 10 levels
are available.
In level 0, you can do nothing
with the transmitter.
Tip 4:There is a Flashlight button on the back of the transmitter. Press
and hold the Flashlight button for 3 seconds to turn the flashlight on
or off.
10
0
10
0
ON
Tip 6: To avoid misuse, you can lock the transmitter by pressing the
Up and Down buttons simultaneously. Do it again, and the transmitter
will be unlocked.
Tip 7:For 919C, auto Anti Bark function is available. Short press the
Flashlight button to enable the auto anti bark mode. In dog00 system,
auto anti bark function is automatically disabled and cannot be turned on.
Please turn auto anti bark function off in a timely manner when the system
is not in use.
ON
7
6
8
Step 7:
Check the button
functions. Push the beep button,
and the receiver beeps. Similarly,
press the vibrate button, and the
receiver vibrates. Cap the shock
test kit on the metal prongs, and
press the shock button. If the bulb lights up, the shock
function is normal.
Reset
button
Tip 8: When the transmitter is dead or malfunctioning,
use a toothpick or similar tools to restart the transmitter
by pressing the reset button.
