Aerservice Equipments RECAR160, Инструкция по установке и эксплуатации

Страница: 20 / 24

Tel. +39 049 641 679 | commerciale@aercomponents.it | www.aercomponents.it
20
10. ELECTRICAL CONNECTIONS
The identification plate indicates the type of power supply , the motor current installed and
the maximum current consumption of the fans. The fans of this series are standard single-
phase, three-speed. The electrical connections must be performed by qualified personnel in
compliance with current regulations.
For any fan provided the special electrical wiring. Clarification or for any doubt for electrical
connection, before the wrong way, or contact the installer or directly the technical assistance.
The manufacturer not be determined directly responsible if the wiring will be done incorrectly
causing damage or malfunction of the machine.
Connection diagram below.
12. AERAULIC CONNECTIONS
The duct connections should be made through circular
ducts with the same diameters as those provided on the
machine. The technical sizing of the ducts will still be
carried out as function of the plant and of the pressure
of the heat recovery unit. The machine is not equipped with anti-vibration joints internal joints
on the attack so we recommend preparing these ducts in order to avoid any vibration.
13. VERIFICATION OF CURRENT CONSUMPTION
At full speed , check that the current consumption complies with the limits of the plate expressed
in the case of abnormal consumption turn off the fan and contact our support department.
Warnings:
• All wiring and electrical components used for the installation must comply with the
regulations in force;
• The power line must be made in accordance with the regulations in force;
• Wiring must be done by qualified technicians electricians;
• The current consumption must comply as set out in the data plate
11. HYDRAULIC CONNECTIONS
The drain must be connected by means of a suitable
siphon, ensuring that it is free and the rubber has not
impediments and obstructions.
RE
EN
S2 (mm) = Ht (mm c.a.) x 0.75
Ht: FAN PRESSURE