AERPRO AERA10D
®
Radio Replacement Kit
for 2011-2018 Jeep Wrangler JK
AMHJP1K
Page 7
Step 2
Step 3
Step 1
Using two M4x4 screws from the
AERA10D box, mount the support
bracket to the top of the radio
module in the location shown.
Align and attach one of metal side
brackets to the right side of the
radio module using two M5 x 10
screws from the AERA10D box.
Align and attach the remaining
metal side bracket to the left side
of the radio module using two M5 x
10 screws from the AERA10D box.
Part Two: Attaching the Radio Module Mounting Brackets
FRONT arrow should point
towards the Aerpro logo.
Step 3
Step 2
Step 1
If the vehicle is equipped with
a factory amplifier, connect the
8-pin connector to the AMPLIFIED
connector. All others connect to the
NON AMPLIFIED 8-pin connector.
Set the dial on the side of the
RP4-CH11 interface to Number 4.
Remove the warning sticker
covering the 16-pin plug on the
end of the interface.
Part Three: Main Harness Connections (RP4-JK07-HAR)
NON-AMPLIFIED
AMPLIFIED
Connect the 16-pin and 4-pin
connectors on the RP4-JK07-HAR
Main Harness to the RP4-CH11
interface module.
Section 3: Display, Radio Module and Harness Preparation (cont.)
