Aerotech Soloist MP 10, Руководство по оборудованию

Страница: 27 / 94

Installation and Configuration Soloist MP
2.1.2. Motor Supply Connections (TB102)
N O T E : This product requires two power supply connections. The Motor Supply and Control Supply
must both be connected for proper operation.
Motor power is applied to the Soloist MP Motor Supply connector (refer to Figure 2-2 for locations).
Refer to local electrical safety requirements to correctly size external system wires and match wires to
fuses or circuit breakers.
W A R N I N G : Do not operate the Soloist MP without the safety ground connection in place.
Figure 2-2: Motor Bus Input Connections
Table 2-3: Motor Supply Input Wiring (TB102)
Pin Description
Recommended Wire Size
(1,
2)
DC+ 10 - 80 VDC Bus Power Input (5 A cont., 10 A peak)
0.5 mm
2
(#20 AWG)
DC-
Bus Power Common Input
(1)
0.5 mm
2
(#20 AWG)
Protective Ground (Required for Safety)
0.5 mm
2
(#20 AWG)
(1) For an isolated DC supply, connect DC- to protective ground at the supply.
(2) Refer to local electrical safety requirements to correctly size external system wires.
Table 2-4: Mating Connector Part Numbers for the Motor Supply Connector (TB102)
Description Aerotech P/N Phoenix P/N
Tightening
Torque (Nm)
Wire Size:
mm
2
[AWG]
7-Pin Terminal Block ECK01389 1803620 0.22 - 0.25 2.0 - 0.516 [14-30]
www.aerotech.com Chapter 2 27