Aerotech LaserTurn 1 Series, Руководство по оборудованию

Страница: 20 / 58

Installation LaserTurn
®
1 Hardware Manual
2.7. Load Capability
The LaserTurn
®
1 is designed for tubular manufacturing applications. With this in mind, the tubes loaded into
the collet chuck of the rotary axis must fall within the maximum load parameters in Section 1.3.
N O T E : Maximum loads are mutually exclusive. Loading limits are due to the collet chuck mechanism.
Contact Aerotech directly if part load requirement exceeds specifications.
If the LaserTurn
®
1 is configured for wet cut, it will have a rotary union attached to the end of the rotary shaft
( Figure 2-5 ). A 1/8 in NPT tapped hole is provided on the end of the rotary union shaft to allow for connecting
a pressure vessel or extension tube. To prevent damage or performance degradation of the stage, the
unsupported length and weight of the attached pressure vessel is limited.
N O T E : Aerotech recommends the following limitations on the size and weight of an unsupported
pressure vessel:
l
Length past end of rotary union (L): <200 mm
l
Moment about end of rotary union (M): <0.75 N-m
If these limits are exceeded, it is recommended that an external steady-rest or support be implemented.
Figure 2-5: LaserTurn
®
1 Wet Cut Rotary Union Location
20 Chapter 2 www.aerotech.com