Aerotech HexGen HEX300-230HL, Руководство по оборудованию

Страница: 14 / 44

1.3. Understanding Basic HEX300-230HL Operation
1.3.1. Hexapod Axes
The hexapod platform can be actuated in six degrees of freedom by changing the lengths of the six
struts that connect the platform to the base. Since the axes of motion are not obvious from the
mechanics of the hexapod, the axis convention is outlined below. These axes can be used to orient
the hexapod in the global workspace. Refer to the HexGen
®
Programming Guide for more
information about controlling hexapod motion. To get a copy of this guide, go to the Resources
section of www.aerotech.com. Select the Manuals and Help Files tab. Then download Hexapod
Programming User Guide from the User Guides category.
The six axes include 3 translational axes, X, Y, and Z, and 3 rotational axes, A, B, and C. As shown in
the overview, the cables exit out of the back of the base. The positive direction of the X axis goes to
the right when looking at the front of the hexapod, and the Z axis goes up vertically. The Y axis goes
toward the back of the hexapod. Rotational axes are oriented in the same direction as the
translational axes, and positive rotation is clockwise when looking in the direction of the axis. The A
axis rotates about the X axis, B rotates about the Y axis, and C rotates about Z. The control software
enables the user to customize the coordinate system with certain restrictions. Please refer to the
HexGen Programming guide for details regarding coordinate system manipulation.
Figure 1-2: Axis Orientation
1.3.2. Strut Limits and Hexapod Range
Limits on the strut keep the strut within the useable travel range. When any strut has reached the
end of travel in either direction, an error will occur in the controller. Because the ranges of the
hexapod axes are interdependent, the limits of the hexapod axes are not constant, and the range of
motion of a hexapod cannot be concisely described. Refer to
Section 1.2. for the independent travel
of each hexapod axis and the strut travel. If a strut limit is triggered, the hexapod is out of range. In
this case, follow the directions of the controller to return the hexapod to a position within the range
of motion. Refer to the HexGen
® Programming Guide for more information.
1.3. Understanding Basic HEX300-230HL
Operation HEX300-230HL Hardware
Manual
14 www.aerotech.com