Aerotech BLMF Series, Руководство пользователя

Страница: 23 / 36

BLMF Hardware Manual Assembly and Installation
2.4. Track Stacking
To increase the linear motor travel distance, magnet tracks can be stacked end-to-end as shown in Figure 2-
2 .
Figure 2-2: Stacking Tracks
2.5. Position Transducer Resolution
The motion controller requires the use of a position transducer for all forms of motion control. This is typically
a linear encoder. The specific application determines the encoder resolution.
2.6. Cable Management
A high-flex cable management system must be used to connect the forcer and feedback signals to the
stationary motion controller. The cable that exits the BLMF forcer is not a high-flex type, therefore it must
terminate before entering the cable management system (refer to
Figure 2-3 ). Termination of the forcer and
encoder cable is in most cases through a D-shell connector. A mating D-shell connector serves as the
termination point of the high-flex cable in the cable management track.
Figure 2-3: Linear Motor with Tape Scale Encoder and Cable Management
www.aerotech.com Chapter 2 23