Aerotech BL 10-40, Руководство по оборудованию

Страница: 19 / 68

Installation and Configuration BL
2.2. Power Connections
The BL has two AC input connectors; one for control power, and a second for motor power. For a complete
list of electrical specifications, refer to Section 1.1.
2.2.1. Control Supply Connections
The control power supply input allows the BL to maintain communications if the motor power is removed,
such as in an Emergency Stop condition. The control power supply requires a minimum of 85 VAC input to
operate properly. The AC1 input is internally fused (at 3 A). AC2 may require an external fuse or circuit
breaker (3 A, time delay).The figure below shows the required connections to the control power input.
N OT E : This product requires two power supply connections. The Motor Supply and Control Supply must
both be connected for proper operation.
Figure 2-1: Control Supply Connections
Table 2-1: Control Supply AC Input Wiring
Pin Description Recommended Wire Size
AC1 85-240 VAC Control Power Input 2.00 mm
2
(#14 AWG)
AC2 85-240 VAC Control Power Input 2.00 mm
2
(#14 AWG)
Protective Ground (Required for Safety) 2.00 mm
2
(#14 AWG)
Table 2-2: Control Supply Terminal Block Mating Connector
Type Aerotech P/N Phoenix P/N Wire Size: AWG [mm
2
]
3-Pin Terminal Block ECK00213 1754465 12-30 [3.3 - 0.0516]
www.aerotech.com Chapter 2 9