Aerotech Automation1 XL2e, Руководство по оборудованию

Страница: 27 / 92

Chapter 2: Installation and Configuration
The sections in this chapter include details on how to set up the electrical and safety components of
your system. Obey all safety warnings, including those in
Safety Procedures and Warnings .
2.1. Input Power Connections
The drive has two DC input power connectors. One connector is for control power and the other
connector is for motor power. For a full list of electrical specifications, refer to
Section 1.1. Refer
to Section 2.7. for a System Interconnection Drawing.
2.1.1. Control Supply Connector
The Control Supply input supplies power to the communications and logic circuitry of the drive . The
+24V input is connected to an internal fuse. Refer to Table 5-4 for the internal fuse value and part
number. For an isolated DC supply, connect 0V to protective ground at the supply. Use twisted pair
wiring to minimize radiated noise emissions (refer to Figure 2-1 ).
IMPORTANT : Refer to local electrical safety requirements to correctly size external
system wires.
Figure 2-1: Control Supply Connections
Table 2-1: Control Supply Connector Wiring Specifications
Pin Description Recommended Wire Size
+24 V
24 VDC (±10%) Control Power Input
(2 A max, 0.75 A typical without brake)
0.34 mm
2
(#22 AWG)
0 V Control Power Common Input 0.34 mm
2
(#22 AWG)
Protective Ground 0.34 mm 2 (#22 AWG)
Table 2-2: Mating Connector Part Numbers for the Control Supply Connector
Type
Aerotech
P/N
Third Party
P/N
Screw
Torque: N·m
Wire Size:
mm
2
[AWG]
3-Pin Terminal Block ECK02456 Phoenix 1839610 0.22 - 0.25 2.5 - 0.05 [14-30]
XL2e Hardware Manual Chapter 2: Installation and Configuration
www.aerotech.com 27